Cart 0 Product Products (empty)
No products
TBD Shipping
$0.00 + Shipping Total
Product successfully added to your shopping cart
Quantity
Total
There are 0 items in your cart. There is 1 item in your cart.
Total products
Total shipping TBD
Total + Shipping
MIL-STD-461 CS109
MIL-STD-461 CS109
CS109 Purpose
MIL-STD-461 CS109 Conducted Susceptibility, Structure Current, 60 Hz to 100 kHz
This test procedure is used to verify the ability of the EUT to withstand structure currents.
Test Equipment
The test equipment shall be as follows:
a. Signal generator
b. Amplifier (if required)
c. Isolation transformers
d. Current probe
e. Measurement receiver
f. Resistor, 0.5 ohm
g. Coupling transformer
Get Application Support, Pricing, Lead Time and More: Contact Form
MIL-STD-461 CS109 There are 8 products.
Showing 1 - 8 of 8 items
AE Techron 7224 Linear Power Amplifier
In Stock- Rentals Ship Same Day
- Up to 900 watts RMS power output
- Small signal response up to 400 kHz
- Up to 16A at 13.5 VDC
- Stable when driving highly capacitive loads.
- Four-quadrant operation.
- Use for Military and Automotive Compliance
- 120V Input
AE Techron 7234 Industrial Power Amplifier/Battery Simulator
Typically in Stock- Powered from 120V/230VAC
- Source and Sink (4 quadrant)
- Drop outs and surges as fast as 1.2µs
- Small signal response up to 1 MHz
- 13.5 VDC at up to 28A
- Field-selectable ±40V, 75V or 150V potential
MFG-1000 Magnetic Field Generator & Ripple Current Tester
In Stock- Magnetic field tests and measurement DC to 250 kHz
- Complies to all relevant EMC, Automotive and Military Standards
- Magnetic field strength up to 1000 A/m at 1000 Hz
- Fully automated tests with triaxial Helmholtz coil
- Wide choice of accessories
Schwarzbeck LFPA 9733 Power Amplifier 5Hz - 1MHz
In Stock- 5 Hz to 1 MHz
- Multi-Purpose Power Amplifier
- Typical applications are magnetic immunity testing;
- According to automotive standards or MIL-461 E or F
- Frequency range (nominal): 5 Hz - 1 MHz
- Gain at 8 ohm impedance: 26 dB ±3 dB
Em Test CWS 500N3 Test Generator for Mil-STD-461, ISO 11452 and More
In Stock- Most compact equipment for ripple noise on ac/dc supplies and magnetic fields
- Built-in LF signal generator
- Built-in LF amplifier
- Built-in LF transformer 2:
- Built-in frequency-selective voltage and current meter
- Built-in load resistors
- Automatic self-calibration
- Frequency Range: 10 Hz - 250 kHz
Schwarzbeck NFPA 9730 Power Amplifier DC - 250 kHz
In Stock- Multi-purpose Power Amplifier
- Can be used within the Frequency Range from DC to 250 kHz
- Typical applications are magnetic immunity testing according to automotive standards or MIL-461F
- Frequency range (nominal): DC - 250 kHz
- Gain at 8 ohm impedance: 26 dB ±3 dB
EM Test CN 200N1 Audio Transformer Assembly for LF Conducted Immunity Testing
In Stock- One-box transformer and 0.5 ohm load assembly
- Frequency response 10 Hz to 250 kHz
- Secondary saturation 50 A per transformer
- Audio power 2 x 200 W
- Freely configurable on primary/secondary; serial, parallel, single
- Turns ratio 2:1 step down
- Built-in non-inductive load resistor 0.5 ohm, 250 W
Solar Type 9124-1N Clamp On Current Probe, 1 kHz - 200 MHz
Typical Lead Time 4 - 6 Weeks- Frequency range: 1 kHz - 200 MHz
- Transfer impedance (ZT): .001
- Continuous signal current (CW): 50 A
Showing 1 - 8 of 8 items