Cart 0 Product Products (empty)
No products
TBD Shipping
$0.00 + Shipping Total
Product successfully added to your shopping cart
Quantity
Total
There are 0 items in your cart. There is 1 item in your cart.
Total products
Total shipping TBD
Total + Shipping
1 GHz Broadband RF Preamplifiers
1 GHz Broadband RF Preamplifiers
Clean up the signal going into your spectrum analyzer, EMC receiver or other meter by using a preamplifier and identify the troublespots that may be buried in the noise. Rent, buy, or lease various Broadband RF Preamplifiers rated to 1 GHz. The EMC Shop specializes in signal integrity and radiated emissions testing.
1 GHz Broadband RF Preamplifiers There are 7 products.
Showing 1 - 7 of 7 items
PA2500M Low Noise Amplifier, 1 - 2500 MHz
- Frequency Range of 1 MHz to 2500 MHz
- Low Noise Figure: 4.0 dB
- High Gain: 30 dB minimum, 31.5 dB Typical
- Low VSWR: 2:1 Typical
- Maximum Power A 1 dB: + 6 dBm
- Flatness: +/- 0.7 dB
- Individually Calibrated (gain calibration included)
$1,195.00Typically In StockHP 8447F-H64 RF Amplifier 9 KHz to 1300 MHz
- .009 MHz - 1300 MHz
- 25 dB Gain
$199.00Typically In StockCom-Power PA-102 Preamplifier 1-1000MHz 32dB Gain
In Stock- Wide Frequency Range - 1 MHz to 1 GHz
- Improved measurement system sensitivity during EMC compliance testing
- Amplify the signals that were previously hidden below the noise floor
Teseq LNA 6901 Low Noise Amplifier 9 kHz to 1 GHz
In Stock- Frequency range: 9 kHz to 1 GHz (nominal range); 9 kHz to 2 GHz (utilizable range)
- Gain: typ. 28 dB
- Gain flatness: ±1 dB
- RF-Input: N - female, 50 Ω (optional N-male)
- RF-Output: N - male, 50 Ω (optional N-female)
- VSWR (input): <1.5
- Noise figure: typ. 2.8 dB (at 25°C, 100 MHz)
- 1 dB-compression (output): +8 dBm
Schwarzbeck BBV 9745 Broadband Preamplifier
In Stock- 9 kHz – 2 GHz Nominal Frequency Range
- 2.5dB (1.0 GHz) Noise figure
- General purpose broadband preamplifier
- With high gain and low internal noise
- Very useful for the measurement of very low limits
Com-Power PAM-103 1 MHz - 1000 MHz Preamplifier for EMI/EMC Measurements
Typically In Stock- Broadband Frequency Range of 1 MHz - 1000 MHz
- Low Noise Figure: less than 6 dB
- High Gain: 33 dB
- Low VSWR: 1.3:1 Max
- Output Power: +4 dBm @ 1 dB compression
- Flatness: ± 3 dB
- Reverse Isolation: Greater than 30 dB
- Impedance: 50 Ohms
- Connector: N-type (f)
Com-Power PAP-501 EMC Preamplifier, 10 MHz - 1000 MHz, 21 dB Gain
Typically In Stock- Small Form Factor
- Extremly Portable
- Perfect Preamp for Near Field Probe Sets
Showing 1 - 7 of 7 items