Com-Power LI-1100C Line Impedance Stabilization Network 150 kHz to 30 MHz

Write a Review
SKU:
sku-17
$4,720.00
$4,720.00

Description

The LI-1100 Line Impedance Stabilization Network (LISN) provides the necessary measurement platform for performing power line conducted emissions compliance testing as required by most worldwide standards for commercial products. The LI-1100 is compliant with both CISPR 16-1-2 and ANSI C63.4.

The LISN provides defined stable impedance and isolates the EUT from power source influences, thereby providing accurate and repeatable results. The LI-1100 includes one pair of, separately housed, single-conductor networks, to be installed in series with each current-carrying conductor in a single-phase, dual-phase or DC power system. A second LI-1100 pair can be used to accommodate 3-phase power systems (Wye or Delta configurations).

The LI-1100 is equipped with Superior Electric SUPERCON® shrouded sockets at the mains (power input) and EUT (power output) ports. The matching color-coded plugs for connection to the mains and EUT wiring are included. This LISN uses air-core inductors to prevent saturation and permeability variation. The mounting plate of the LI-1100 is left unpainted in order to facilitate connection to earth ground in its installation, which is essential due to high leakage current.

Use of a Transient Limiter for impedance matching, reduction of out-of-band emissions and transient protection for your measurement instrument is highly recommended and available from Com- Power. All Com-Power LISNs are individually calibrated in compliance with the relevant requirements of CISPR 16-1-2 and ANSI C63.4. Impedance, Phase, Isolation, and Insertion Loss data is supplied with each unit, along with the calibration certificate.

Typical Connection Diagrams

Single Phase connection with one set of LISN

Single Phase connection with one set of LISN

Three Phase connection with two sets of LISNs

Three Phase connection with two sets of LISNs

Calibration

All Com-Power LISNs are individually calibrated in compliance with the relevant requirements of CISPR 16-1-2 and ANSI C63.4. Impedance, Phase, Isolation, and Insertion Loss data is supplied with each unit, along with the calibration certificate.

Line Impedance Stabilization Network Chart

Com-LI-1100 Line Impedance Stabilization Network Chart

Com-LI-1100 Line Impedance Stabilization Network Chart

Extra Information

Weight:
17 lbs. / 7.7 kg
Application/Test Type:
Power line conducted emissions tests
Current Rating:
100 Amps (AC), 70 Amps (DC)
Dimensions:
10 x 10 x 21 inches /25.4 x 25.4 x 53.3 cm
Frequency Range:
150 kHz to 30 MHz
Inductors:
50 µH (air-core)
Insertion Loss:
0.5 dB (150 kHz to 30 MHz)
Isolation:
40 dB (150 kHz to 30 MHz)
Mains & EUT Connections:
Superior Electric SUPERCON® shrouded sockets - Input: 120 VAC 60Hz, Output: 12 VDC 1 Amperes (Fan Power Adapter)
RF Connector:
50Ω N-type (female)
Standards Met:
CISPR 16-1-2 / ANSI C63.4
Voltage Rating:
440 VAC (Line to Ground), 620 VDC