Send Enquiry For Schwarzbeck TK 9420 High Voltage Probe
Schwarzbeck TK 9420 High Voltage Probe
- 9 kHz - 30 MHz
- High Voltage Probe
- 1.5 kOhm
- 4 pF
- RF < 30 V
Cart
0
Product
Products
(empty)
No products
TBD
Shipping
$0.00 + Shipping
Total
Product successfully added to your shopping cart
Quantity
Total
There are 0 items in your cart. There is 1 item in your cart.
Total products
Total shipping
TBD
Total
+ Shipping
Schwarzbeck Field Probes
-
Schwarzbeck Antennas
- Schwarzbeck Automotive Antennas
- Schwarzbeck Broadband Horn Antennas
- Schwarzbeck Biconical Antennas
- Schwarzbeck Logarithmic Periodic Broadband Antennas
- Schwarzbeck Stacked Log-Periodic Broadband Antennas
- Schwarzbeck Biconic Log-Periodic Antennas
- Schwarzbeck Dipole Antennas
- Schwarzbeck Rod Antennas
- Schwarbeck Antenna Baluns / Holders
- Schwarzbeck LISN Line Impedance Stabilisation Networks
- Schwarbeck Decoupling & Absorbing Clamps
- Schwarzbeck Field Probes
- Schwarzbeck Helmholtz Coils
- Schwarzbeck Antenna Masts
- Schwarzbeck Coupling/Decoupling Networks
Schwarzbeck Field Probes
Rent, buy or lease Schwarzbeck Field Probes. The EMC Shop specializes in RF immunity and compliance testing.
Schwarzbeck Field Probes There are 14 products.
-
-
Schwarzbeck CMDM 8700 Common Mode / Differential Mode Switch
- 9 kHz – 30 MHz Frequency
- Measurement modes: Line A, Line B, Common mode, Differential mode
- Connectors: BNC (50 Ohm)
-
Schwarzbeck CP 9610 Current Probe 40A DC - 1 MHz
- 40A DC - 1 MHz Current Probe
- It is galvanically isolated
- Can withstand a maximum voltage of 210 VPK / VDC
- BNC (1 MΩ) Output Connector
- -40 A - +40 A Current Sensing Range
-
Schwarzbeck CVP 9222 B High Impedance Capacitive Voltage Probe
- 9 kHz - 100 MHz Frequency Range
- High Impedance Capacitive Voltage Probe
- Acc. to CISPR 22
- EN 55022 C 1.3
-
Schwarzbeck CAL 9222 Calibration Jig for Capacitive Voltage Probe CVP 9222
- Calibration Jig for Capacitive Voltage Probe CVP 9222
- Used to measure the transducer of the Capacitive Voltage Probe CVP 9222
-
Schwarzbeck EFS 7103 Active Electric Field Probe
- 9 kHz - 1 GHz Frequency Range
- Field Strength Measuring Range: 40 to 140 dBµV/m
- Frequency Response: +/- 4 dB
-
Schwarzbeck EFS 9218 Active Electric Field Probe
- Active Electric Field Probe with Biconical Elements
- 9 kHz - 300 MHz
- 12 µV/m - 65 V/m
- Const. antenna factor typ. 46 dB/m high symmetry
- Built in rechargeable battery
- The switchable preamplifier improves the antenna factor to 20 dB/m.
-
Schwarzbeck EW 7110 DC Separator
- The DC-Separator EW 7110 is used for powering the Probes HFSL 7101, HFSH 7102 and EFS 7103.
- The DC-Separator and the named Probes are available in a practical case in FS-SET 7100.
- The power adapter ACDC 7110 is required for operation.
-
Schwarzbeck FSHPE Single Axis E-Field Antenna
- 9 kHz - 300 MHz Frequency Range (nominal)
- 9 kHz - 500 MHz Frequency Range (useable)
- Passive, single-axis Efield probe
- Suited for non-ionizing radiation measurements according to BGV-B11, ICNIRP, IEEE C95.1, FCC 96-236 and others
- Allows a fast an accurate safety-evaluation of the measurement environment
-
Schwarzbeck FSHPH Single Axis H-Field Antenna
- 9 kHz - 300 MHz Frequency Range
- Passive, single-axis H-field probe
- Suited for non-ionizing radiation measurements according to BGVB11, ICNIRP, IEEE C95.1, FCC 96-236 and others
- Allows a fast and accurate safety-evaluation of the measurement environment
- Can be directly mounted to the spectrum analyser
- Can be held manually at its 50 mm shaft (sweeping method) or;
- Attached to a mast or tripod using the 22 mm tube (rotation method or raster method)
-
Schwarzbeck FSE3D Isotropic 3-axial RX Antenna
- Frequency range: (10) 30 MHz - 3 (3.3) GHz
- Isotropic E-Field Antenna
- For handheld spectrum analyser
- Light weight low attenuation radom
- Outer diameter approx. 150 mm
-
Schwarzbeck FMZB 1512 Active Handheld RX Loop Antenna
- 9 kHz - 30 MHz Frequency Range
- Active Receiving Loop Antenna
- Active shielded handheld loop antenna
- With nearly constant antenna factor over the entire frequency range
- It can be used for testing acording to CISPR, MIL, FCC, EN, ISO, ANSI, ETSI and many other standards
