EMC & EMI Testing There are no products in this category.

Subcategories

• 

  RF Conducted Immunity Testing Services

  The EMC Shop has the ability to perform CDN, EM Clamp, BCI, TWC and DPI injection methods for RF conducted immunity testing and compliance. Common test standards include ISO 11452-4, IEC/EN 61000-4-6, MIL-STD-461 CS114, IEC/EN 61000-4-16, IEC/EN61000-4-19 and more.

• 

  Radiated Immunity & Susceptibility Testing

  The EMC Shop will has a fully anechoic test chamber to perform radiated immunity and susceptibility testing to IEC 61000-4-3, ISO 11452-1, MIL-STD 461 RS103 and other requirements up to 40 GHz and 600 V/m pulse.

  Radiated Immunity & Susceptibility Testing Services

  

• 

  EMI/EMC Testing for Automotive Equipment

  The EMC Shop offers EMI/EMC testing services for automotive equipment and components used in road vehicles.

  Test Standards for EMI/EMC Testing for Automotive Equipment & Components

  • ISO 7637
  • ISO 16750-2
  • ISO 10605
  • ISO 11452
  • CISPR 25
  • CISPR 12
  • SAE J113
  • Ford FMC1278
  • GMW 3097
  • UNECE Regulation 10
  • UL 2231-2
• 

  FCC Part 15 Precompliance Testing

  Save time and money to ensure you get your product certified on the first attempt. The EMC Shop offers precompliance testing services for FCC Part 15.

  The FCC regulates radio frequency (RF) devices contained in electronic-electrical products that are capable of emitting radio frequency energy by radiation, conduction, or other means. These products have the potential to cause interference to radio services operating in the radio frequency range of 9 kHz to 3000 GHz.

  Almost all electronic-electrical products (devices) are capable of emitting radio frequency energy. Most, but not all, of these products must be tested to demonstrate compliance to the FCC rules for each type of electrical function that is contained in the product. As a general rule, products that, by design, contain circuitry that operates in the radio frequency spectrum need to demonstrate compliance using the applicable FCC equipment authorization procedure (i.e., Supplier's Declaration of Conformity (SDoC) or Certification) as specified in the FCC rules depending on the type of device. A product may contain one device or multiple devices with the possibility that one or both of the equipment authorization procedures apply. An RF device must be approved using the appropriate equipment authorization procedure before it can be marketed, imported, or used in the United States.

  The following discussions and descriptions are provided to help identify whether a product is regulated by the FCC and whether it requires approval. The more difficult issue, but not covered in this document, is how to categorize an individual RF device (or multiple components or devices within an end product) to determine the specific FCC rule part(s) that apply, and the specific equipment authorization procedure or procedures that need to be used for FCC compliance purposes. This determination requires technical understanding of the product, as well as knowledge of the FCC rules.