Schwarzbeck FSH3D Isotropic 3-Axial RX Loop Antenna

Schwarzbeck

Write a Review
SKU:
sku-1391
$0.00
$0.00

Description

The Schwarzbeck FSH3D consists of three identical, shielded loop antennas, which are aligned perpendicularly to each other. A shielded unit follows, containing the switching and amplifier circuitry, which is directly connected to the N-male output and fed by the Binder-connector with power supply and logic signals to select the desired loop-axis. The pin assignment is ready for operation with the popular handheld spectrum analyzers FSH3/6 and FSH 4/8 from Rohde & Schwarz.

A RF-transparent radome cover protects the FSH3D from dust and moisture. Because of its lightweight construction the FSH3D can be directly mounted to the spectrum analyzer. Alternatively the FSH3D can be held manually at its 50 mm shaft (sweeping method) or attached to a mast or tripod using the 22 mm tube (rotation method or raster method).

Electric Antenna Factor Magnetic Antenna Factor

Frequency [MHz]

Frequency [MHz]

Maximum Fieldstrength Measuring Range

Noise floor (RMS, BW: 200 Hz)

Frequency [MHz]

Frequency [MHz]

VSWR at N-Connector

Frequency [MHz]

Specifications
Frequency Range (nominal) 9 kHz - 200 MHz
Frequency Range (useable) 9 kHz - 300 MHz
Coaxial Connector (male) N
Power Supply 5 V DC < 100 mA
Power Supply and Logic Connector Binder 99-0421-10-07 Serie 712
Antenna Factor for fictional E-fieldstrength 42...70 dB/m
VSWR typ. < 1.5 (20 kHz - 50 MHz)
Decoupling of the axis typ. > 20 dB
1 dB Compression at Output typ. 118 dBµV
Loop Diameter 112 mm
Dimensions 550 x 146 x 146 mm
Weight 850 g
Environmental Conditions -10°C - +50°C, IP54

Control:

The active loop can be selected using the spectrum analyzer. Only one of three loops can be active at a time. The logic signals are labeled with TTL1 and TTL2, a logical 1 is represented by a voltage of 3.2 - 5 V. The alignment of the loop planes can be seen in the picture below. The loop of axis 2 lies in the cleavage plane of the radome. The loop planes 1 and 3 are standing vertically and perpendicular to each other, as depicted in the picture. The maximum field strength indication of a respective loop is achieved with the magnetic field lines going perpendicularly through the loop plane.

Binder 99-0421-10-07 Serie 712
Pin 1 +5 V, max. 100 mA
Pin 4 GND
Pin 5 TTL1
Pin 6 Connected to Pin 1
Pin 7 TTL2

TTL1 TTL2
Rahmen / Loop 1 1 0
Rahmen / Loop 2 1 1
Rahmen / Loop 3 0 1
Reset 0 0

Extra Information

Brand:
Schwarzbeck