Automotive Transient Immunity Generators

Quick Links

Information

Viewed products

Rent 3ctest TIS 700 Automotive Transient Simulator ISO 7637 Pulse 1,2a,3a/b View larger

Rent 3ctest TIS 700 Automotive Transient Simulator ISO 7637 Pulse 1,2a,3a/b

Used

  • Economic Alternative for Automotive EMC Compliance
  • Meets ISO 7637 Pulses 1, 2a, 3a and 3b
  • Built-in EFT/Burst generator module
  • Built-in Micropulse generator module (ISO 7637, JASO, SAE and NISSAN)

More details

Typically In Stock

Request Quote/More Info

Specifications

Input DC voltage from APS, APG or other DC source
Electrical Fast Transients
EFT/Burst module for test pulses 3A/3B
Parameter Value
Test Voltage 25 - 700 VOlts
Rise time 5ns ± 30%
Pulse duration 150ns ± 45ns
Verification As per Annex C of ISO 7637-2:2011 into 50ohm and 1,000ohm load
Source Impedance 50ohm
Polarity Positive/negative (Pulse 3b/3a)
Trigger of bursts Automatic, manual, external
Burst duration 0.1ms - 99.9ms
Repetition rate 50ms - 999ms
Spike frequency 0.1kHz - 200kHz
Test duration 1 s - 50000 seconds
Outputs Direct Via 50ohm-coaxial connector (for tests using e.g. a capacitive coupling clamp); Coupling mode To the battery line (supply lines); CRO trigger 5V trigger signal for oscilloscope
Micropulse
Micropulse module for test pulses 1, 2A and 6
Parameter Value
Test voltage 30 - 600 Volts
ISO PULSE 1 (12V) 0.5us - 1us. 1.5us - 3us. No load, 1ms 土 20% no load 1ms 土 20% 50 ohm matching load 2ms 土 20% no load
ISO PULSE 1 (24V) 0.5us - 1us. 1.5us - 3us. No load, 1ms 土 20% no load 1ms 土 20% 50 ohm matching load 2ms 土 20% no load
ISO PULSE 2 (12V/24V) 0.5us - 1us. 1.5us - 3us. No load, 1ms 土 20% no load 1ms 土 20% 50 ohm matching load 2ms 土 20% no load
Trigger automatic, manual, external, battery switch
Output DUT supply +/- Central DUT output; Coupling To the battery +line; Decoupling Via diode and battery supply switch

Test Equipment Description

The 3ctest TIS 700 series for automotive transient generation unifies the capabilities of an EFT/Burst simulator, a micro pulse simulator and the required coupling network in one box. The TIS 700 series are equipped to meet all international and car manufacturer specifications. The current of built-in coupling networks range up to 100 Amps depending on the model. The built-in coupling network can be used and controlled by any unit od the LDS200 series, APG series and APS series. For tests beyond standards requirements the waveform parameters of the micro pulse generator can be varied in a wide range by means of the freestyle mode.

3ctest TIS 700 Includes:

  • ISO 7637 Simulator Pulse 1, 2a and 3
  • Power Cord (120V AC)
  • User Manual
  • Calibration Certificate

How to Rent the 3ctest TIS 700:

**These units can be shipped standard UPS or FedEx, but air-freight only and insured. Preferred shipping method is crated via a Freight Carrier.

  • Click "Add to Cart" above
  • Shipping Section - Select "Use My Account" - Indicate in the Notes section if you'd like us to facilitate shipment or if your logistics team will do so.
  • Checkout Accordingly
  • An EMC Shop representative will contact you with shipping estimates or logistics details.

30 other products in the same category: