ISO 16750-2

For EMC certification the ISO 16750-2 is used in conjunction with ISO 7637-2 transient generators,.

STANDARD OVERVIEW

This part of ISO 16750-2 requires electric and electronic systems/components in road vehicles to apply potential environmental stresses and specifies voltage disruptions and transients. The current edition of ISO 16750-2 saw updates to every test, aligning with UN ECE R10.

REQUIRED TESTS

Direct current supply voltage
Overvoltage
Superimposed alternating voltage
Slow decrease and increase of supply voltage
Discontinuities in supply voltage
Reversed voltage
Ground reference and supply offset
Open circuit tests
Short circuit protection
Withstand voltage
Insulation resistance
Electromagnetic compatibility

TEST ADDITIONS TO EDITION 5

introduction of use of operating mode for the electrical tests
introduction of concept with redundant supplies for relevant test cases
introduction of transient overvoltage test
introduction of micro interruption in supply voltage test

As well as a complete update of superimposed alternating voltage test (e.g. updated test method, extension of frequency range to 200 kHz, etc.)

PROGRAMMABILITY

ADJUSTABLE WAVEFORM PARAMETERS
IN MOST TEST EQUIPMENT

TEST SETUP

ISO 16750-2 references EMC specifications but there is no defined test setup or environment as they aren't considered electromagnetic compatibility tests.

Performance measurements from the referenced EMC standards are not included in the scope of the ISO 16750 series.

DIY

EMC TEST GENERATOR VIDEO OVERVIEW

Using AWG from 3ctest with LDS, TIS and APS Systems.

SAME DAY SHIPPING

The EMC Shop specializes in the electrical stress testing according to ISO 16750-2 and other test standards for electric vehicles, batteries, and charging stations.