MIL-STD-461 CS114

CS114 Purpose

Conducted Susceptibility, Bulk Cable Injection (BCI)

The MIL-STD-461 CS114 requirement is applicable from 10 kHz to 200 MHz for all interconnecting cables, including power cables.

The MIL-STD-461 CS114 test procedure is used to verify the ability of the EUT to withstand RF signals coupled onto EUT associated cabling.

Test Equipment

The test equipment shall be as follows:

a. Measurement receivers

b. Current injection probes (maximum and minimum insertion loss shown on Figure CS114-2)

c. Current probes

d. Calibration fixture: coaxial transmission line with 50 ohm characteristic impedance, coaxial connections on both ends, and space for an injection probe around the center conductor.

e. Directional couplers

f. Signal generators

g. Plotter h. Attenuators, 50 ohm

i. Coaxial loads, 50 ohm

j. Power amplifiers

k. LISN

The EMC Shop offers turn key solutions to complete conductred susceptibility tests required per MIL-STD-461 CS114.

Get Application Support, Pricing, Lead Time and More: Contact Form

MIL-STD-461 CS114 There are 20 products.

per page
Showing 1 - 12 of 20 items
Showing 1 - 12 of 20 items