Surge Simulation (Power & Telecom Lines)

IEC 61000-4-5 is the most commonly referenced international standard to meet eelctrical surge/combo wave test requirements for power and telecom lines. Specialized surge simulators are available to meet specialized industrial and aerospace applications.

Surge Simulation (Power & Telecom Lines) There are 28 products.

per page
Showing 1 - 12 of 28 items
  • 4-6 Weeks
    Request Quote/More Info
    • Surge voltage up to 10kV
    • Generator designed to comply with IEC 60065
    • Generator designed to comply with UL 6500
    • Interlock
    • Warning lamp control
    • Manual operation
    • USB (optical link) and GPIB interface
    4-6 Weeks
    Request Quote/More Info
    • Automated test modes, software assisted test preparation, predefined test routines and visual aided test setups
    • Automatic generation of test report, including test parameters, test setup and test result
    • Compliance and pre-compliance testing of electrical products
    • Includes
    • CE marking
    • Product development and debugging
    • Compliance testing of telecom and wireless devices
    $18,750.00
    Typically In Stock
    Request Quote/More Info
    • IEC/EN 61000-4-5 & ANSI C62.45: SurgeModule up to 5kV
    • IEC/EN 61000-4-4: Burst Module up to 5.5kV
    • IEC/EN 61000-4-11: Dips Interrupts and Variations
    • Built in Single phase 300 Volt/16 Amp coupler
    • Manual operation from front panel
    • USB and GPIB-Bus for remote control
    • Monitor outputs for peak voltage and peak current
    • Fail inputs
    • External variac control 0-10Vdc
    6 - 8 Weeks
    Request Quote/More Info
  • Typical Lead Time 6 - 8 Weeks
    Request Quote/More Info
    • Rentals Ship Immediately
    • System Configuration:
      • E103 Controller (fiber-interface for remote control)
      • E411 EFT/Noise Burst Simulator to 4.4 kV (IEC 61000-4-4)
      • E501B Surge Simulator to 6.6 kV (IEC 61000-4-5, ANSI C62.41 Cat. B and UL 1449 at 3kA)
      • E4551A Single Phase Surge/EFT Coupler 250V rms (typ. 15 Amps)
      • Input voltage: 100V to 240VAC
      • Input Current: 3.5A at 100 V; 1.5A at 240 V
    $975.00
    4-6 Weeks
    Request Quote/More Info
  • 1 Review(s)
    • Combination wave
      • Voltage: 1,2/50us
      • Current: 8/20us
    • Impulse voltage: 200V - 4.2kV
    • Impulse current: 100A - 2.1kA
    • Maximum impulse repetition rate 12 per minute
    • Positive, negative and user definable alternating polarity
    • Integrated CDN for 16A at 264Vac and 110Vdc
    • Impulse voltage, current and EUT current measurement
    • Test parameter ramp functions
    • Phase angle synchronization
    $895.00
    Typically In Stock
    Request Quote/More Info
    • Floating high voltage output
    • Combination wave 1.2/50us - 8/20us
    • 7.4kV impulse voltage
    • 3.7kA impulse current
    • Impulse voltage & current monitors
    • Accurate phase angle synchronization
    • Meets standards:
      • UL 1449
      • IEC 61000-4-5
      • ANSI C63.4
      • And more!
    $1,799.00
    Request Quote/More Info
    • Rent the Keytek ECAT System
    • System Configuration:
      • E103 Controller (fiber-interface for remote control)
      • E411 EFT/Noise Burst Simulator to 4.4 kV (IEC 61000-4-4)
      • E501B Surge Simulator to 6.6 kV (IEC 61000-4-5, ANSI C62.41 Cat. B and UL 1449 at 3kA)
      • E4551A Single Phase Surge/EFT Coupler 250V rms (typ. 15 Amps)
      • Input voltage: 100V to 240VAC
      • Input Current: 3.5A at 100 V; 1.5A at 240 V
    $9,500.00
    In Stock
    Request Quote/More Info
    • 10" Color Touch Screen
    • Intelligent HV Mains Charging Mode
    • Automatic Control System, Failure Analysis and more
    • Built in Single or Three Phase CDN
    • 300V - 10kV (±10%) Output Voltage
    • Configure with 10/700 Telecom Wave if Required
    4-6 Weeks
    Request Quote/More Info
    • Three high voltage inputs
    • Combination wave 1.2/50us-8/20us
    • Ring wave 100kHz
    • 8kV impulse voltage
    • Line voltage 690Vac phase-phase
    • 32A EUT Current per phase
    • Phase angle synchronization for each path
    4-6 Weeks
    Request Quote/More Info
    • Complies to FCC TIA-968-B and CS03 standards
    • Standard Test routines software and manual operations
    • Built-in CDN for AC power ports
    • Fiber optic RS232 interface
    • Lightning Simulator
    Typically In Stock
    Request Quote/More Info
Showing 1 - 12 of 28 items