EMIC-20 EM Injection Clamp for IEC/EN 61000-4-6 Immunity Test

Write a Review
SKU:
sku-524
$0.00
$0.00

Description

The preferred coupling and decoupling devices for IEC/EN 61000-4-6 immunity testing are the CDNs, for reasons of test reproducibility and protection of the AE. However, if they are not suitable or available, clamp injection should be used.

Often, clamp injection needs to be applied to multi-pair balanced cables because suitable CDNs might not be available. The EMIC-20 EM injection clamp establishes both capacitive and inductive coupling to the cable connected to the EUT.

The EM clamp (in contrast to the conventional current injection clamp) has a directivity ≥ 10 dB, above 10 MHz, so that defined impedance between the common-mode point of the AE and the ground reference plane is no longer required. Above 10 MHz, the behaviour of the EM clamp is similar to that of a CDN.

 

EMIC-20 Includes:

  • EM Clamp - 20mm Diameter
  • Adapter N-plug/BNC-jack
  • Calibration Set Including
    • QTY 2 Mounting Brackets with 150 to 50 Ohm adapters
    • BNC Termination, 50 Ohm, 1 Watt
    • Brass Rod with banana plugs
    • Adaptor with two banana plugs
  • User Manual
  • Calibration Certificate
  • 10% off Calibration Service for Life

Videos

Extra Information

Weight:
approx. 7 kg
Application/Test Type:
Injects the disturbance signal through a combination of inductive and capacitive coupling
Clamp factor (CF):
-.5 dB at 100 kHz to -4 dB at 1 GHz (Min -7 dB at 700 MHz
Connector:
N-type female
Dimensions:
632 mm x 120 mm x 80 mm
Frequency Range:
10 kHz to 1000 MHz
Impedance:
50 Ohms
Max. Cable Diameter:
20 mm
Maximum Continuous Power:
0.15 to 100 MHz: 100 W for 15 min; 100 to 230 MHz: 100 W for 5 min; 230 to 1000 MHz: 50 W for 3 min
Standards Met:
IEC/EN 61000-4-6; CISPR 24; EN 61000-6-1; EN 61000-6-2; IEC 60533; IEC 60601-1-2; IEC 61326