Com-Power LI-3P-1100 150 kHz - 30 MHz Three-Phase Line Impedance Stabilization Network

Com-Power

Write a Review
SKU:
sku-600
$0.00
$0.00

Description

Com-Power LI-3P-1100 150 kHz - 30 MHz Three-Phase Line Impedance Stabilization Network consists of 50Ω / 50 μH. These LISNs provide the necessary measurement platform for performing power line conducted emissions compliance testing as required by most worldwide standards for commercial products. The LISNs perform each of the following functions during the measurement:
  • provide a defined, stable impedance across the measurement frequency range;
  • isolate the EUT and measurement circuit from the power source, thereby minimizing its influence on the measurements; and,
  • couple the disturbance voltages to the coaxial measurement port, which connects to the measuring instrument.

The LISNs use air-core inductors to prevent saturation and permeability variation. The mounting plates are left unpainted in order to facilitate connection to earth ground in their installation, which is essential due to high leakage currents. The side panels for each LISN are louvered for cooling purposes. The LI-3P-163 and LI-3P-1100 also include two internal cooling fans operated by a switch on the rear panel.

Remote or Local Operation

Remote switching of the line under test (L1, L2, L3, N) is performed using the RLI-100 Remote LISN Interface, which controls the LISN via fiber optic connection.

Com-Power LI-3P-116 Remote or Local Operation

Remote switching of the line under testRemote switching of the line under test

In addition to the remote method, the line under test can also be selected using the mechanical, four-position switch located on the front panel of the LISNs. Using either switching method, the lines which are not selected are internally terminated into 50 ohms, while the selected line is terminated by the 50 ohm input impedance of the measuring instrument.

Calibration

Each LISN is individually calibrated in compliance with the relevant requirements of CISPR 16-1-2 and ANSI C63.4. Impedance, Phase, Isolation, and Insertion Loss data is supplied with each unit, along with the certificate of calibration. Recognized ISO 17025 accredited calibration is also available upon request.

Typical Data

Com-Power LI-3P-116 Typical Impedance Data
Typical Impedance Data
Com-Power LI-3P-116 Typical Phase Data
Typical Phase Data
Com-Power LI-3P-116 Typical Insertion Loss
Typical Insertion Loss

Com-Power LI-3P-116 Typical Isolation Data

Typical Isolation Data

Extra Information

Brand:
Com-Power
Weight:
71.5 lbs
Application/Test Type:
Power Line Conducted Emissions Tests
Current Rating:
100 Amperes
Frequency Range:
150 kHz to 30 MHz
Inductors:
50 µH
Insertion loss:
less than 0.7 dB
Isolation:
more than 40 dB
Mains & EUT Connections:
Remote Interface Power Input Port 5.5/2.5 mm Power Jack
RF Connector:
RF Measurement Port 50Ω - N-Type (female)
Standards Met:
ANSI C63.4, CISPR 16-1-2
Voltage Rating:
500 Volts rms (line to line), 288 Volts rms (line to ground) Max DC Voltage: 705V