MIL-STD-461 RE102

RE102 Purpose

Radiated emissions, electric field.

This requirement is applicable for radiated emissions from equipment and subsystem enclosures, and all interconnecting cables. For equipment with permanently mounted antennas this requirement does not apply at the transmitter fundamental frequencies and the necessary occupied bandwidth of the sig...

RE102 Purpose

Radiated emissions, electric field.

This requirement is applicable for radiated emissions from equipment and subsystem enclosures, and all interconnecting cables. For equipment with permanently mounted antennas this requirement does not apply at the transmitter fundamental frequencies and the necessary occupied bandwidth of the signal.

This test procedure is used to verify that electric field emissions from the EUT and its associated cabling do not exceed specified requirements.

RE102 Limits

Electric field emissions shall not be radiated in excess of those shown on Figures RE102-1 through RE102-4. Above 30 MHz, the limits shall be met for both horizontally and vertically polarized fields.

Test Equipment

The test equipment shall be as follows:

a. Measurement receivers.

b. Data recording device.

c. Antennas:

(1) 10 kHz to 30 MHz, 104 cm rod with impedance matching network. The signal output connector shall be bonded to the antenna matching network case.

(a) When the impedance matching network includes a preamplifier (active rod), observe the overload precautions in 4.3.7.3.

(b) Use a square counterpoise measuring at least 60 cm on a side.

(2) 30 MHz to 200 MHz, Biconical, 137 cm tip to tip.

(3) 200 MHz to 1 GHz, Double ridge horn, 69.0 by 94.5 cm opening.

(4) 1 GHz to 18 GHz, Double ridge horn, 24.2 by 13.6 cm opening.

d. Signal generators.

e. Stub radiator.

f. Capacitor, 10 pF.

g. LISNs

Get Application Support, Pricing, Lead Time and More: Contact Form

More

MIL-STD-461 RE102 There are 4 products.

Showing 1 - 4 of 4 items
    • Broadband: 200 MHz to 2 GHz
    • Transmit and receive capabilities
    • Individual calibration
    • Three year warranty
    • 800 Watts of CW Power Handling
    $6,505.00
    Request Quote/More Info
    • Suitable for Mil-STD 461 and DO-160
    • Frequency Range of 9 KHz to 30 MHz
    • Built in Amplifier
    • Battery Power: 6V NimH Input: 6 VDC 500mA
    • Calibration to ANSI C63.5 ESCM
    Request Quote/More Info
    • Suitable for Mil-STD 461 and DO-160
    • Frequency Range: 9 kHz to 30 MHz (useable up to 60 MHz)
    • Included Remote Antenna Interface (RAI-100)
    • Built in Amplifier
    • Battery Power: 6V NimH Input: 6 VDC 500mA
    • Calibration to ANSI C63.5 ESCM
    Request Quote/More Info
    • Rentals ship immediately
    • 85 MHz Bandwidth Analysis Option (Fastest Testing Possible)
    • Real-Time Analysis up to 85 MHz BW
    • Quasi-peak, EMI-avg, RMS-avg and diagnostic detectors
    • Meets CISPR 16-1-1: 2010 and MIL-STD-461F EMI receiver requirements
    • Purchase a Used Keysight N9038 EMI Analyzer here.
    Request Quote/More Info
Showing 1 - 4 of 4 items